Lithofin MN Stain-Stop – Bulk Buy – 500mL, 1L , 5L – Protects against staining

Lithofin MN Stain-Stop further information

Coverage: depends on the absorbency of the stone.

Estimates:

• polished surfaces: 12 to 15 m2/L
• very dense stones: up to 40 m2/L
• rough/honed granite: 5 to 7 m2/L
• porous sandstone: 3 to 6 m2/L

For all natural and artificial stone

Lithofin MN Stain-Stop penetrates into the surface and coats the capillaries with an extremely thin, invisible film.
Oil, grease and water are therefore no longer absorbed by the surface, but remain on the surface (12 to 48 hours on polished marble and limestone, up to 60 hours on granite and gneiss). During this time, oil can easily be removed without leaving stains. The effectiveness depends on the amount of product absorbed by the surface. The appearance of the natural stone is not affected. Some stones may become slightly darker in colour. The water absorbency of the stone is greatly reduced; the water permeability is only slightly affected. The product is UV-resistant and does not yellow.

Lithofin MN Stain-Stop Technical Data

Density: approx. 0.8 g/cm3
Flash Point: about 32°C
Odor: slightly aromatic
Appearance: liquid, colourless
Reduction of water absorbency: approx. 90 to 95% Permeability: approx. 80 to 90%

Field of Use

For invisible protection against staining and for facilitating maintenance of all natural stone surfaces, including polished marble. Perfect for use on wall and floor surfaces in the kitchen and bathroom, as well as on table tops, window sills and other sensitive surfaces. Suitable for indoor and outdoor use.

Please Note: marble and limestone will remain sensitive to acid.

Lithofin MN Stain-Stop Directions for Use

The surface to be treated must be absorbent, clean and completely dry.
Suitable application tools: cloth, brush or sponge.
Without prior experience or in cases of doubt, try the product in an inconspicuous area prior to use. On large surfaces, work in small sections of 10 to 15m2.

Apply Lithofin MN Stain-Stop generously until the surface appears wet. Allow the product to penetrate for approx. 15 minutes. Redistribute the excess product and remove puddles and streaks. On highly absorbent materials or on dry spots more product may have to be added. Remove all remaining product residues within 30 minutes using a dry cloth. On large surfaces use a squeegee to remove excess with a polishing machine and a white pad.

Attention! the liquid product must penetrate into the stone. Do not allow the product to dry on the surface.

Please Note: non-absorbent or damp surfaces cannot be impregnated. Glass, ceramics, and surfaces sensitive to solvents (varnishes, wood, etc.) must be protected against splashes.

Application Temperature: the temperature of the surface should be between 10°C and 25°C. Switch off under floor heating. Drying Time: after approx. 2 hours surface will be dry and ready to be stepped on carefully. Drying process will be complete after 24 hours, do not cover or use suction lifters during this time. Wipe up any spills immediately. The full effectiveness of the impregnator is reached after 5 days.

Durability

Up to 5 years on outdoor surfaces. Indoors the durability depends on the care products used. Strong de-greasing or layer forming products are unsuitable. Heavily used surfaces such as kitchen counters and vanity tops should be touched up once a year with the solvent-free Lithofin STAINSTOP >W<. Advice: immediately remove stain causing substances. For regular maintenance of floors we recommend Lithofin MN Wash&Clean, for kitchen counter tops Lithofin MN Easy-Clean.

Lithofin MN Stain-Stop Storage

Closed, cool and dry up to 3 years. Open containers should be used without delay.