Rocatex CG2 WA Ultimate Grout more information:
Fibre Reinforced, Flexible, Anti-Mould, Wall & Floor Grout, 1-20mm, 5kg
Areas of Use:
- Ceramic / Porcelain / Natural Stone / Mosaics
- Timber / Underfloor Heating
- Swimming Pools / Wet Areas
- Domestic / Commercial
- Interior / Exterior
Rocatex CG2 WA Ultimate Grout technical information:
Conformity | Conforms to the requirements of BS EN 13888 Class CG2 WA |
Application temperature | 5°C to 25°C |
Mixing ratio | 1.6 litres of water to 5kg of powder |
Pot life | 45 mins at 20°C |
Wash off time | After 20 mins at 20°C |
Set time | 90 mins at 20°C (walk on) 12 hrs at 20°C (full cure) |
Joint width | 1-20mm |
Protein free | Yes |
Shelf life | 12 months in cool dry area |
Preparation:
Ensure the tiles are firmly fixed and the joints are clean, dry, free from all loose matter including dust, dirt, grease, excess adhesive, bedding mortar and any other contaminants.
Mixing:
Mix 5kg of ROCATEX CG2 WA Ultimate Grout with approximately 1.6 litres of cold clean tap water until a smooth creamy consistency is achieved using a suitable drill with whisk attachment. Mix at a slow speed for a minimum of 2 minutes to ensure that all ingredients (polymers, retarding agents, colour pigments etc.) are dispersed thoroughly throughout the whole mix. Allow to stand for 2 minutes then re-mix.
Preparation:
Use a suitable grout float or squeegee to work the grout deeply into the joints ensuring the joints are completely filled. Excess grout should be removed as work proceeds and any residues left on the tile face can be removed by wiping off with a damp sponge once the grout has stiffened in the joints (approximately 20 minutes after application). Any dry film remaining on the surface can be removed by polishing off with a dry cloth when the grout has hardened in the joints.
Mixing:
Mix 5kg of ROCATEX CG2 WA Ultimate Grout with approximately 1.6 litres of cold clean tap water until a smooth creamy consistency is achieved using a suitable drill with whisk attachment. Mix at a slow speed for a minimum of 2 minutes to ensure that all ingredients (polymers, retarding agents, colour pigments etc.) are dispersed thoroughly throughout the whole mix. Allow to stand for 2 minutes then re-mix.
Application:
Use a suitable grout float or squeegee to work the grout deeply into the joints ensuring the joints are completely filled. Excess grout should be removed as work proceeds and any residues left on the tile face can be removed by wiping off with a damp sponge once the grout has stiffened in the joints (approximately 20 minutes after application). Any dry film remaining on the surface can be removed by polishing off with a dry cloth when the grout has hardened in the joints.
Do not apply if frost is forecast within 24 hours, in wet conditions, in temperatures below 5°C or above 25°C, to areas in direct sunlight or to substrates that are hot.
There are no reviews yet.