Everbuild Tarmac Restorer extended information
HIGH PERFORMANCE SURFACE COATING TO MAKE TARMAC LOOK NEW
EVERBUILD Tarmac Restorer is a high performance surface coating specially formulated to make existing tarmac look like new. Once dry it provides a tough, durable, low sheen finish which protects from weathering, oil and petrol spills and unsightly plant/weed growth. The quick drying formula enables driveways to be used after only 4 hours.
Uses
- Tarmac drives
Characteristics / Advantages
- Tough and long-lasting
- Protects against common spills and plant / weed
growth - Fast-drving
Everbuild Tarmac Restorer product information
Chemical Base | Water-based acrylic polymer |
Packaging | 5L jerry can |
Appearance / Colour | Black |
Shelf Life | 12 months from date of manufacture. |
Storage Conditions | Store in original containers in cool dry conditions above 5°C (max 25°C). Do not allow to freeze. |
Density | 0.9 – 1.1 g/cm3 |
Viscosity | 400 - 700 cP |
Chemical Resistance | Resistant to: most salt solutions, dilute acids and alkalis, water and limited oil. Not resistant to: solvents and some detergent solutions. |
Consumption / Yield / Dosage (PRINT single line) | 4 – 6m2 per litre depending on porosity of substrate |
Product Temperature | -20°C to +50°C |
Ambient Air Temperature | 5°C to 35°C. Surfaces must be free from ice and water. |
Curing Time | 4-6 hours depending on drying conditions |
APPLICATION INSTRUCTIONS
SUBSTRATE QUALITY / PRE-TREATMENT
All surfaces must be clean and free from any loose dirt or debris. The surface may be damp, however any surface water/puddles must be removed. Use Everbuild Oil Away to remove any oil or grease spills. Lichen or surface mould can be removed using Everbuild Fungicidal Wash and cleaned using fresh water and a stiff bristle brush. Surface imperfections should be repaired using Everbuild Quick Mac or suitable repair compound.
APPLICATION
Always read instructions prior to use. Stir well before and periodically during use. Apply with a brush or long pile roller in an even coat across the entire surface.
Apply in 2 coats allowing 4 hours between coats.
CLEANING OF TOOLS
Clean all equipment immediately after use with clean water and detergent.
LIMITATIONS
- Do not use if ambient air or surface temperature is below 5°C.
- Do not use if rain is imminent (within 6 hours).
- Do not use over fresh tarmac. Allow tarmac to dry for a minimum of 3 months prior to application.
- Do not subiect to vehicular traffic within 4 hours of application.
- At lower temperatures drying times will be significantly extended. Always check surface is dry before trafficking.
- Oil, petrol or chemical spills should be removed from EVERBUILD Tarmac Restorer as quickly as possible with warm water, detergent and a clean cloth.
- Do not use a high pressure spray to clean EVER-BUILD Tarmac Restorer.
- It is the user’s responsibility to determine suitability for use. If in any doubt contact Technical Services for advice.
There are no reviews yet.