Everbuild Instant Nails – Bulk Buy

Everbuild Instant Nails extended information

LIMITATIONS

• At least one surface must be porous.
• In damp, cold or humid conditions curing time may be significantly extended.
• Do not use in permanently damp/wet conditions.
• Do not use in situations where both surfaces are non-porous (e.g. plastic/plastic or metal/metal): use
  EVERBUILD GUN A NAIL EXTRA.
• Do not use as a mirror adhesive: use EVERBUILD Mirror Mate.

SUBSTRATE PREPARATION

The surfaces to be glued should be clean and free from dust, grease and other contaminants. Wood, plaster and brick may be damp but not running wet (NOTE: this will slow down the drying time). Use mechanical abrasion to clean porous surfaces if necessary before application.

APPLICATION METHOD / TOOLS

• Surfaces must be sound, clean, dry and free from dust, grease, loose material etc. At least one surface must be porous.
• Prime dusty surfaces with EVERBUILD 501 PVA BOND diluted 1:4 with water and allow to dry.
• Cartridge: apply using a standard sealant gun, cut tip of cartridge, apply nozzle and cut an opening to suit the required bead size.
• Easi-squeeze tube: remove cap and cut nozzle to suit the required bead size.
• For bonding heavy items (plasterboard/worktops/ wall panels, etc) apply adhesive all the way around the edge of the item (30-50 mm from edge) and cover back with beads of adhesive at 300 mm intervals. Alternatively, apply adhesive direct to battens and press into place.
• With heavy items, always provide temporary support until the adhesive dries.
• For bonding lightweight items (covings, dado rails, skirting, etc) apply adhesive to back of item in one or two continuous beads and press immediately into place
• Where gap-filling is required, mark the areas where there is a large gap and apply a thicker bead to these areas.
• In all cases, clean up excess adhesive immediately with a damp cloth.

Everbuild Instant Nails product information