Everbuild Everflex AC50 Acoustic Sealant
Packaging | 380ml and 900ml cartridges |
Colour | White |
Shelf Life | 12 months from date of manufacture when stored in unopened cartridges. |
Storage Conditions | Store in cool (5 - 25°C) dry conditions and protect from frost. |
Density | 1.55 - 1.65 g/cm3 |
Solid Content | ca. 80% |
Everbuild Everflex AC50 Acoustic Sealant technical information
Shore A Hardness | Approximately 40 |
Elongation at Break | 100-200% (DIN 53504) |
Movement Capability | Low to medium (+/- 5%) |
Chemical Resistance | Dilute Acids - Fair Dilute Alkaline - Fair Aliphatic Hydrocarbons - Fair AromaticHydrocarbons - Poor |
Service Temperature | -15°C to +70°C |
APPLICATION INSTRUCTIONS
SUBSTRATE PREPARATION
All surfaces must be clean and dust free. All loose or flaking surface coatings, and old sealant and mastic joints, should be removed before application. Highly porous substrates such as new plaster should first be primed with Everbuild PVA bond diluted 1:4 with water. Surfaces may be slightly damp, but not wet. NOTE: THIS WILL SLOW THE CURE.
APPLICATION METHOD / TOOLS
900ml size: Fit cartridge into a 1ltr mastic gun. Cut nozzle to required length and puncture inner membrane seal before applying.
C4 Packs: Cut the tip of the cartridge taking care not to damage the thread. Apply nozzle and cut cleanly at an angle of 45°.
Use as a sealant: Always cut nozzle to a size slightly larger than the gap to be sealed. Apply to gap, slightly overfilling and finish smooth with a caulking tool or filler knife. Clean up any excess with a damp cloth within 30 minutes of application.
Use as an adhesive for direct bonding to large surfaces: Cut nozzle to provide a bead of approximately 9-10mm diameter and apply a continuous bead to one surface at 250-350mm centres. Apply board immediately to surface and tamp down. Provide temporary support until cured.
Use as an adhesive for bonding to studding: Apply a continuous bead to studding and apply board immediately into position. Do not apply more than one boards width of studding at one time. Provide temporary support until cured.
Everbuild Everflex Contract AC50 LIMITATIONS
- Should not be used against bituminous materials.
- Damp or humid conditions will significantly extend the cure time.
- Do not attempt to abrade when cured.
- Do not overpaint until product has fully cured. This will normally be 24 hours but may be 4-5 days in damp, cold or humid conditions.
- Do not apply below 5°C.
- For overhead boarding applications, always use in conjunction with mechanical fixings.
There are no reviews yet.